Southern Voting Behavior Essays - Free Essays, Term Papers

Southern Voting Behavior Essays - Free Essays, Term Papers Southern Voting Behavior Southern Voting behavior since the 1960?s Voters in many areas of the U.S. are apt to vote differently as a whole from election to election. The nation has also had a decreased turnout rate for the presidential and local elections. The South has typically not followed these patterns that the rest of has seemed to be following. The Southern whites of the U.S. have typically followed and voted for the more conservative candidate and party. Where as the Southern blacks have typically (when they have been able to vote) voted for the more liberal party or candidate. The South was at one time a Democratic stronghold and has in the past 30 years become a typically conservative voting electorate. This tendency of voting by race for the liberal or conservative candidate has been a continuing occurrence. Southern turn out for elections has been significantly lower than the rest of the nation as well over the same time period. This bias of the past 30 years as well as voter turn out has only recently began to change in the So! uth. In the beginning of and prior to the 1960?s the South was a Democratic stronghold and it was rare for there to be any competition from Republicans in these non competitive states (Mulcahy p.56). A poll taken in the 1960?s showed that " the southern states were the obvious stronghold of Democratic identification. The extreme case was Louisiana, where 66% identified with the Democratic party"(Black p.44). This all began to change as the Democratic party became more liberal in its national policy views. The Democrats became too liberal in their policies concerning civil rights for the white Southerners to continue voting for them. (Mulcahy p.40). This reason along with others is what drove the Southern whites to change there voting habits of the last 100 years. The white Southerners began to vote for presidents of the Republican party and for Independents such as the Dixiecrats, because they were more conservative on a national scale. The Largest change of the Southern voters o! ccurred in 1960 when "the southern white Protestant presidential vote went Republican"(Wayne p62). This would of allowed for the democrats to lose the south if the black electorate had not voted Democrat. The black Southern voters at the time of the 1960?s were just again able to participate with their rights to vote. This was because shortly after the Civil War and reconstruction the Southern whites reduced and eventually removed the short lived black political power. They added laws that made it mandatory to take tests for voter eligibility, as well as discouraging black voting at all. This discrimination greatly reduced if not completely halted black voting in the south until the 1950?s and 1960?s. It was not until 1965 that the Voting Rights Act was passed that prohibited literacy tests for federal elections did blacks obtain their constitutional right to vote (Wayne p.70). Many blacks did in fact support the Republican party for quite a long time because they were known as the party of reconstruction and freeing of the slaves. Black voting turned towards the Democrats in the 1930?s and 40?s on the advice of "One N.A.A.C.P. leader? Turn your pictures of Lincoln to the wa! ll, the debt is paid in full"(Mulcahy p 37). This black voting for the Democrats created a problem in of its self, that the Blacks were continuing to vote for the local white conservative Democrats, that upheld the traditional Southern white views. This lead to the continued power of the oppressive whites, even though the party platform was one of reform. It was not until the early 70?s that when the Republicans won the election for the governor of Virginia was the two party system fully revived in the south (U.S. news p. 210). This two party system allowed Democrats to run on a more liberal platform, which gave the blacks the representation that they wanted. Voting in the South since the 1960?s has followed the pattern of voting for the most staunch conservative, or protector of Southern whites views. In the 1968 election Southern whites in the Deep South voted for George C. Wallace, while the rest of the

Troubleshooting Problems in Crystal Growing

Troubleshooting Problems in Crystal Growing There may come a time when you will try to grow a crystal without success. Here are some ideas for possible problems and ways to correct them: No Crystal Growth This is usually caused by using a solution that isnt saturated. The cure is to dissolve more solute into the liquid. Stirring and applying heat can help to get solute into solution. Keep adding solute until you start to see some accumulate at the bottom of your container. Let it settle out of solution, then pour or siphon the solution off, being careful not to pick up undissolved solute. If you dont have any more solute to use, you can take some comfort in knowing that the solution will become more concentrated over time, as evaporation removes some of the solvents. You can speed this process by increasing the temperature where your crystals are growing or by increasing air circulation. Remember, your solution should be loosely covered with a cloth or paper to prevent contamination, not sealed. Saturation Problems If you are sure your solution is saturated, try to eliminate these other common reasons for the lack of crystal growth: Too much vibration:Â  Keep your crystal set up in a quiet, undisturbed location.Contaminant in the solution:Â  The fix is to re-make your solution. The fix only works if you can avoid contamination (wont work if your starting solute is the problem). Common contaminants include oxides from paper clips or pipe cleaners (if youre using them), detergent residue on the container, dust or something else falling into the container.Inappropriate temperature:Â  Experiment with temperature; you may need to increase the temperature around your crystals to get them to grow (increases evaporation). For some crystals, you may need to decrease the temperature (which slows the molecules down and gives them a chance to bind together).Solution cooled too quickly or slowly:Â  Did you heat your solution to saturate it? Should you heat it? Should you cool it? Experiment with this variable. If the temperature changed from the time you made the solution to the present time, the rate of cooling might ma ke a difference. You can increase the rate of cooling by putting the fresh solution in a refrigerator or freezer (faster) or leave it on a warm stove or in an insulated container (slower). If the temperature didnt change, maybe it should (heat the initial solution). Water wasnt pure:Â  If you used tap water, try re-making the solution using distilled water. If you have access to a chemistry lab, try deionized water that was purified by distillation or reverse osmosis. Remember: water is only as clean as its container! The same rules apply to other solvents.Too much light:Â  An unlikely problem with home crystals, but for certain materials, the energy from light can inhibit the formation of chemical bonds.No seed crystals:Â  If you are trying to grow a large single crystal, you will need to get a seed crystal first. For some substances, the seed crystals may form spontaneously on the side of the container. For others, you may need to pour a small amount onto a saucer and let it evaporate to get crystals. Sometimes crystals will grow best on a rough string suspended into the liquid. The composition of the string is important! You are more likely to get crystal growth on cotton or wool string than on nylon or a fluoropolymer.Seed crystals dissol ve when placed in the new container:Â  This happens when the solution isnt fully saturated. See above for details.